Dr. Dabber Switch GO

The Switch GO keeps its oil in the quartz insert and pushes vapour through a glazed ceramic cloud pathway into the glass chamber inside the body. Reclaim builds in the pathway and around the aluminium crown before it becomes obvious in the insert, and because the water chamber is enclosed, water left sitting in it stains faster than it would in a top mounted attachment.

Quick Cleaning (After Each Session)

1. Dry swab the insert: Use a dry cotton swab straight after the dab to mop up leftover oil while the quartz is still warm.
2. Follow with isopropyl: A swab dipped in 91 percent or stronger isopropyl clears anything the dry swab leaves. Dr. Dabber recommends doing this every session rather than saving it up.
3. Wipe the carb cap: The magnetic cap collects reclaim on its underside, and a quick swab keeps it seating properly.

Deeper Cleaning (Every Few Sessions)

1. Run the cleaning assist cycle: In the app settings it warms the insert to 100 degrees for 30 seconds, which loosens residue and makes the insert easier to lift out. It does not count towards the dab counter.
2. Take the top apart: Lift the crown off first, then remove the insert. To free the glass attachment, slide it upwards with your thumbs once the crown is off, then twist and pull it out of the body.
3. Clean the chamber and pathway: Swab isopropyl through the heating chamber, the glazed ceramic cloud pathway and the crown. The silicone seals on the crown and carb cap come off for cleaning, but remove the crown seal carefully so you do not disturb the magnet.
4. Shake the glass out: Fill it with 91 percent isopropyl and shake until the marks lift, adding a tablespoon of table salt for stubborn reclaim. Rinse fully with warm water and air dry before it goes back in.
5. Dry everything before reassembly: Any isopropyl left in the pathway will show up in the next hit.

Care Tips for Better Results

• Keep isopropyl off the outer shell, as it will damage the finish. Use a damp paper towel with a little dish soap and avoid the charging port.
• Fill the glass to just above the perc holes, with the attachment out of the body. Overfilling causes splashback.
• Empty the water when you are not using it for a while, especially if the rig is packed for travel.
• Torching inserts is not recommended and they are not covered by warranty.
• Let the unit cool for around 20 minutes after three or more back to back cycles, and charge from below 15 percent rather than leaving it on the cable. Our battery guide explains why.

The Switch GO is aimed at people who liked what the Switch 2 does but never wanted to carry it. At 152mm tall and 363 grams it is closer to a large water bottle than a table rig, the glass lives inside the body where it is hard to knock over, and the quartz insert means there is no atomizer to buy every few months. That combination makes it one of the more sensible portable concentrate options if you dab away from home, and the travel guide covers the practical side of moving a rig with water in it.

The compromises are runtime and headroom. Dr. Dabber quotes 20 to 25 heating cycles against 30 on the Switch 2, the insert is 14mm rather than 20mm, and the smaller water chamber cools less on the hottest settings. It also drops induction for resistance heating, which most reviewers describe as a slightly more controlled, less aggressive hit rather than a worse one. Single degree control and custom heating curves need the app, and on iOS that runs through the LabLink browser rather than the App Store. If you want a cheaper way into a small rig, the XS has four fixed settings and no app, and the premium list covers what else sits at this price.