DynaVap The G3

Cleaning the G3 is the simplest job in the DynaVap range. There are only two parts, no o-rings, no condenser and no removable screen, so resin has one place to build up: the inside of the glass unibody, from the bowl down past the airport to the mouth end. Because the screen is fused into the glass, the whole airpath cleans in one soak.

Quick Cleaning (After Each Session)

1. Wait for the cooldown click: Then give the glass another minute before you handle it. Thermal shock is the main way these break.
2. Tap the bowl out: Turn the unibody over and knock the spent material free, or lift it out with the digger-outer tab on the cap.
3. Wipe the airport: A dry cotton bud over the circular airport keeps the draw consistent.

Deeper Cleaning (Every Few Sessions)

1. Separate the two parts: Slide the Captive Cap off the glass. That is the whole teardown.
2. Soak the glass unibody: Drop it in 90 percent or stronger isopropyl for 15 to 30 minutes, or overnight if it is badly loaded. Warm water and dish soap does the same job more slowly, and the Pink Slip supplied with United States orders works in hot water.
3. Never soak the cap: Swab the inside with a cotton bud instead. Moisture caught in the crimped end will damage the cap the next time you heat it, and DynaVap asks for 24 hours of drying if one does get wet.
4. Rinse in hot water and dry fully: Any alcohol left in the glass is a fire risk once the torch comes out, so let it dry completely before the next session.
5. Lift torch soot off the cap: Metal polish or a baking soda paste removes scorch marks. Keep abrasive pads off the glass.

Care Tips for Better Results

• Do not push a tool into the glass to scrape residue. Soaking does the work and a hard tool will chip the bore.
• Store it in the supplied tin between sessions. Glass and pockets do not mix.
• Keep the grind medium rather than fine so the fused screen does not clog. See our grind guide.
• Heat higher on the cap for lighter, more flavorful draws and lower for thicker vapor, then adjust with our temperature guide.
• The 0.05g bowl is small, so a light pack still fills it. Overloading is the usual cause of a restricted draw.

At $35 with a torch and a case included, the G3 is the cheapest honest way to find out whether the DynaVap approach suits you, which is why it belongs on our vaporizers under $100 and portable budget vaporizers lists. The glass airpath means no metallic note in the vapor and no condenser to soak, so it is genuinely one of the easiest vaporizers to clean: pull the cap, drop the body in isopropyl, rinse. A fixed 0.05g bowl also makes it a natural fit for microdosing, where a full M sized chamber would be more than you want.

The limits are real. Glass is fragile, so this is a device for a desk or a padded case rather than a jeans pocket, and DynaVap advises against induction heaters because of the material. There is no condenser and no taper, so it will not drop into a water pipe and the draw runs warmer than a longer stem would. Nothing swaps either: tips, condenser assemblies, dosing capsules and the DynaCoil are all listed as incompatible, so the G3 is a finished device rather than a platform. If you want a starter that can grow, look at the B2 or read convection vs conduction before you decide.