Arizer Air SE

Every load goes inside the 70mm Glass Aroma Tube rather than into the Air SE itself, so resin settles along the bore of that stem and around the built-in glass screen at its packing end. Arizer calls the Air SE Micro Heater essentially maintenance free, and its isolated airpath is why: fresh air passes the ceramic element, but vapour only touches glass.

1. Stir the tube out while it is warm. Work the stainless steel stir stick around the inside of the tube to lift the spent plug, then tip it away. A 0.25g load lifts out in one piece before the residue sets.

2. Give the glass a long soak. Arizer asks for roughly two hours of isopropyl on the Air SE glass, then a hot water rinse, and a second pass if staining survives. The 70mm tube and any tipped, curved or 110mm stems you add later take the same treatment. Let hot glass reach room temperature first, because a cold rinse cracks borosilicate. Glass is excluded from the warranty; the heating element is covered for life.

3. Swap a clogged screen instead of saving it. Four steel filter screens come in the box, but Arizer treats them as optional and says they make vapour harsh, because every tube carries its own glass screen. Replacements sell in packs, so retire a slow one.

4. Keep liquid outside the body. Nothing gets poured into the heater opening, the unit must never be immersed, and the shell is not meant to be opened. A dry swab at the stem collar is the limit, and our review found the oven stays clean with little intervention.

5. Burn off, then restart the timer. With the glass dry, run level 5, the red 210°C preset, for five to ten minutes to clear any traces. Auto shut-off is fixed at ten minutes on this model, so restart it rather than waiting on a longer cycle.

6. Heat a stem that will not seat. Residue tightens the fit. Choose level 3, the green 200°C preset, wait a minute, then ease the tube in rather than forcing it cold.

7. Mind the cell, the cover and the port. Slide the rear cover down, wipe the 18650 and its contacts, and match positive and negative going back in. Our review noted it is stiff at first and frees up after a few removals. Keep the micro USB port clear of lint, allow about three and a half hours for a full charge, and store spares part charged.

Wash the silicone stem cap and PVC travel tube in warm soapy water, since they hold preloaded stems. A spare aroma tube keeps the Air SE running while the first soaks.

Perfect for outdoor adventures with its replaceable 18650 battery, the Air SE uses hybrid heating to deliver efficient extraction. While it does have some limitations like only supporting preset temperature control, there's still a lot of performance to be found here due to the strong heater similar to other models in their range.

For upgraded features, check out the Arizer Air Max or the classic Arizer Air 2. Learn about optimal temperature settings to get the most from this value-packed Arizer portable.